Amusement equipment installation requirements and initial operation troubleshooting

Natural state, the play equipment on top of the joystick should incline settings. Playground Equipment axis in the plane parked, naturally in a stopped state, this time outside of the shaft section in addition to any downstream jumping gear in deciding his own decline.
Under the following conditions, tackle braking distance jump in the downstream segment of any non-slide segments shall not exceed 8m, jumping segment must not exceed 13m. Shaft dry and clean; normal load; brake before operating speed is the maximum speed. Cockpit board material recommended the use of rubber, rubber and other elastic material, the use of other inelastic material, must tackle the front and rear anti-collision buffer device settings. Arm body steel, wheels, brake blocks connected by bolts or other fastening pin, should be taken to prevent amusement equipment, gear and loosening measures. Pulley with elevated road improvement and upgrading of road accidents involving falling due skid anti-kickback device.
Slewing ring must be fitted with seat belts or other effective protection. Should be sufficient for the required waiting and tourist hub, the place to get off the channel. Distribution should be sufficient for cockpit temporary venues and facilities required. Passengers out of the station to separate play equipment shall not interfere with each other.
Should be equipped with the necessary equipment to play office, ticketing, medical, storage, mechanical and electrical equipment and other auxiliary buildings. The venue should be targeted lighting and standby lighting facilities. Mine facilities set according to the actual situation.
Station house and related buildings must comply with national regulations on fire prevention, playground equipment room next to station should be equipped with the necessary equipment. Between the station house should separate dedicated phone or walkie-talkies with. At least one station house or near the station house outside calls. Line security staff should be equipped with radios may at any time contact with the station house. Electrical Control Circuits slide set should meet GB / T 18878-2002 requirements in 9.3.1.
Station house, wire rope, machinery and equipment and all metal components should be grounded. Ensure reliable lightning protection, grounding resistance value should be checked regularly, and its impulse grounding resistance value requirements are as follows: the station house ≦ 10 ohms; machinery and equipment, steel wire rope and metal components station ≦ 10 ohms, and pay attention to the reliability of the line and equalizing.